Home Articles List Article Information
JES. Journal of Engineering Sciences
Journal Archive
Volume Volume 52 (2024)
Volume Volume 51 (2023)
Volume Volume 50 (2022)
Volume Volume 49 (2021)
Volume Volume 48 (2020)
Volume Volume 47 (2019)
Volume Volume 46 (2018)
Volume Volume 45 (2017)
Volume Volume 44 (2016)
Volume Volume 43 (2015)
Volume Volume 42 (2014)
Volume Volume 41 (2013)
Volume Volume 40 (2012)
Volume Volume 39 (2011)
Volume Volume 38 (2010)
Volume Volume 37 (2009)
Volume Volume 36 (2008)
Volume Volume 35 (2007)
Volume Volume 34 (2006)
Ahmed, M., Hassaneen, Y., Abd El Shafy, Z., Farouk, M. (2010). THE EFFECT OF SOLID PARTS ON THE NON-LINEAR BEHAVIOR OF ONE WAY RIBBED SLABS. JES. Journal of Engineering Sciences, 38(No 6), 1447-1468. doi: 10.21608/jesaun.2010.125569
M. H. Ahmed; Y. A. Hassaneen; Z. E. Abd El Shafy; M. A. Farouk. "THE EFFECT OF SOLID PARTS ON THE NON-LINEAR BEHAVIOR OF ONE WAY RIBBED SLABS". JES. Journal of Engineering Sciences, 38, No 6, 2010, 1447-1468. doi: 10.21608/jesaun.2010.125569
Ahmed, M., Hassaneen, Y., Abd El Shafy, Z., Farouk, M. (2010). 'THE EFFECT OF SOLID PARTS ON THE NON-LINEAR BEHAVIOR OF ONE WAY RIBBED SLABS', JES. Journal of Engineering Sciences, 38(No 6), pp. 1447-1468. doi: 10.21608/jesaun.2010.125569
Ahmed, M., Hassaneen, Y., Abd El Shafy, Z., Farouk, M. THE EFFECT OF SOLID PARTS ON THE NON-LINEAR BEHAVIOR OF ONE WAY RIBBED SLABS. JES. Journal of Engineering Sciences, 2010; 38(No 6): 1447-1468. doi: 10.21608/jesaun.2010.125569

THE EFFECT OF SOLID PARTS ON THE NON-LINEAR BEHAVIOR OF ONE WAY RIBBED SLABS

Article 5, Volume 38, No 6, November and December 2010, Page 1447-1468  XML PDF (936.72 K)
Document Type: Research Paper
DOI: 10.21608/jesaun.2010.125569
View on SCiNiTO View on SCiNiTO
Authors
M. H. Ahmed1; Y. A. Hassaneen1; Z. E. Abd El Shafy2; M. A. Farouk3
1Civil engineering Department, faculty of Engineering, Assiut University
2Lecturer, Civil engineering Department, faculty of Engineering, Assiut University
3Engineer Expert in Ministry of justice.
Abstract
Non-linear behavior of one way ribbed slabs was introduced in this paper. The 3D-FEM model through (ANSYS) program has been used to accomplish this study. In this research the effect of width of middle solid part, the area of compression reinforcements of middle solid part and the width of edge solid parts on the behavior of one way ribbed slabs were studied. The ultimate load, the cracking load, the strain of concrete, stress of steel and deflection were calculated as well as mode of failure was observed. The best ratio of the width of middle solid part to the span of slab and the effect of existence the edge solid parts were concluded.
Main Subjects
Civil Engineering: structural, Geotechnical, reinforced concrete and steel structures, Surveying, Road and traffic engineering, water resources, Irrigation structures, Environmental and sanitary engineering, Hydraulic, Railway, construction Management.
Statistics
Article View: 95
PDF Download: 411