Home Articles List Article Information
JES. Journal of Engineering Sciences
Journal Archive
Volume Volume 53 (2025)
Volume Volume 52 (2024)
Volume Volume 51 (2023)
Volume Volume 50 (2022)
Volume Volume 49 (2021)
Volume Volume 48 (2020)
Volume Volume 47 (2019)
Volume Volume 46 (2018)
Volume Volume 45 (2017)
Volume Volume 44 (2016)
Volume Volume 43 (2015)
Volume Volume 42 (2014)
Volume Volume 41 (2013)
Volume Volume 40 (2012)
Volume Volume 39 (2011)
Volume Volume 38 (2010)
Volume Volume 37 (2009)
Volume Volume 36 (2008)
Volume Volume 35 (2007)
Volume Volume 34 (2006)
Shawki, K. (2009). SIMPLIFY CHARTS FOR THE DESIGN OF VERTICAL FORMWORK SYSTEMS. JES. Journal of Engineering Sciences, 37(No 6), 1359-1367. doi: 10.21608/jesaun.2009.128512
K. M. Shawki. "SIMPLIFY CHARTS FOR THE DESIGN OF VERTICAL FORMWORK SYSTEMS". JES. Journal of Engineering Sciences, 37, No 6, 2009, 1359-1367. doi: 10.21608/jesaun.2009.128512
Shawki, K. (2009). 'SIMPLIFY CHARTS FOR THE DESIGN OF VERTICAL FORMWORK SYSTEMS', JES. Journal of Engineering Sciences, 37(No 6), pp. 1359-1367. doi: 10.21608/jesaun.2009.128512
Shawki, K. SIMPLIFY CHARTS FOR THE DESIGN OF VERTICAL FORMWORK SYSTEMS. JES. Journal of Engineering Sciences, 2009; 37(No 6): 1359-1367. doi: 10.21608/jesaun.2009.128512

SIMPLIFY CHARTS FOR THE DESIGN OF VERTICAL FORMWORK SYSTEMS

Article 3, Volume 37, No 6, November and December 2009, Page 1359-1367  XML PDF (805.06 K)
Document Type: Research Paper
DOI: 10.21608/jesaun.2009.128512
View on SCiNiTO View on SCiNiTO
Author
K. M. Shawki
Assistant Professor, construction and building engineering Dept. Collage of Engineering and Technology Arab Academy for Science, Technology and Martine Transport -Alexandria –Egypt
Abstract
This paper presents simplify charts for the design of traditional wall formwork systems. The first step is to determine the pressure due to fresh concrete using the cement type , concrete weight , rate of placing and the temperature .The second step is to determine the safe distance between studs using plywood thicknesses 19 or 22 or25 mm .The third step is to determine the distance between walls using studs of 50*100 mm (2*4 in) or 50*125 mm (2*5 in) or 50*150 mm (2*6 in) lumber .Finally the safe distance between ties is determined using wale section of double 50*100mm (2*4 in) or 50*125 mm (2*5 in) lumber.
Keywords
wall formwork; construction
Main Subjects
Civil Engineering: structural, Geotechnical, reinforced concrete and steel structures, Surveying, Road and traffic engineering, water resources, Irrigation structures, Environmental and sanitary engineering, Hydraulic, Railway, construction Management.
Statistics
Article View: 139
PDF Download: 376